Back to all

Tire Tread Depth for Grand Rapids, Michigan Drivers

August 26, 2022

Driving on bald tires is like playing roulette. Though you may be fine today, eventually your luck is going to run out.

The Feds don't have any laws for tread depth, but 42 of the states, and all of Canada, do have regulations. They consider 2/32 of an inch to be the minimum legal tread depth. Two other states, including California, consider 1/32 to be the minimum and six states have no standards at all. Call us at Tuffy Grand Rapids; (just call 616.452.4425) to find out what your requirements are in the Grand Rapids, Michigan , area.

Since 1968, U.S. law has required that a raised bar be molded across all tires. When tires are worn enough that this bar becomes visible, there's just 2/32 inch/1.6 mm of tread left. But does that older standard give Grand Rapids vehicles enough safety?

Consider this: Consumer Reports recommends tire replacement when tread reaches 4/32 inch/3.2 mm. And the recommendation is backed by some very compelling studies. Now before we go into the studies, you need to know that the issue is braking on wet surfaces.

We tend to think of the brakes doing all the stopping, but Grand Rapids vehicles also need to have effective tires to actually stop the car. When it's wet or snowy in Grand Rapids, Michigan , the tread of the tire is critical to stopping power.

Picture this: you're driving in Grand Rapids over a water-covered stretch of road. Your tires need to be in contact with the road in order to stop. That means the tire has to channel the water away so the tire is contacting the road and not floating on a thin film of water – a condition known as hydroplaning. When there's not enough tread depth on a tire, it can't move the water out of the way and you start to hydroplane.

This is where the studies come in. We think Grand Rapids drivers will be surprised. A section of a test track was flooded with a thin layer of water. If you laid a dime flat on the track, the water would be deep enough to surround the coin, but not enough to submerge it. 

A car and a full-sized pick-up truck were brought up to 70 mph/112 kph and then made a hard stop in the wet test area. Stopping distance and time were measured for three different tire depths. First, they tested new tires. Then tires worn to legal limits. And finally, tires with 4/32 inch/3.2 mm of tread were tested (the depth suggested by Consumer Reports.)

When the car with the legally worn tires had braked for the distance required to stop the car with new tires, it was still going 55 mph/89 kph. The stopping distance was nearly doubled. That means if you barely have room to stop with new tires, then you would hit the car in front of you at 55 mph/89 kph with the worn tires.

Now with the partially worn tires – at the depth recommended by Consumer Reports – the car was still going at 45 mph/72 kph at the point where new tires brought the car to a halt. That's a big improvement – you can see why Consumer Reports and others are calling for a new standard.

Now without going into all the details, let us tell you that stopping the truck with worn tires needed almost 1/10 of a mile (.16 km)  of clear road ahead to come to a safe stop. How many Grand Rapids drivers follow that far behind the vehicle ahead? Obviously, this is a big safety issue.

The tests were conducted with the same vehicles but with different sets of tires. The brakes were the same, so the only variable was the tires.

How do people in Grand Rapids know when their tires are at 4/32 inch/3.2 mm? Well, it's pretty easy. Just insert an American quarter into the tread. Put it in upside down. If the tread doesn't cover George Washington's hairline, it's time to replace your tires. With a Canadian quarter, the tread should cover the numbers in the year stamp.

Now you may remember doing that with pennies. But an American penny gives you 2/32 inch/1.6 mm to Abraham Lincoln's head. The quarter is the new standard – 4/32 inch/3.2 mm.

Tires are a big ticket item, and most people in Grand Rapids, Michigan , want to get thousands of miles/kilometers out of them. Just remember: driving on bald tires is like playing roulette.

Have Mr. Washington look at your tires today. If he recommends a new set, come see us at Tuffy Grand Rapids in Grand Rapids.

Tuffy Grand Rapids
610 28th St. SE
Grand Rapids, Michigan 49548
616.452.4425

More articles from Tuffy Grand Rapids (28th St.)

The Little Valve that Could (PCV Valve Replacement)

April 21, 2024

It's easy to get letters like PVC and PCV mixed up. PVC is a plastic that's used in a lot of things, especially plumbing pipes. And PCV is a valve that helps your engine burn off excess fumes rather than having them pollute our atmosphere. PCV stands for positive crankcase ventilation. When y... More

Steering You Right (Tie Rod End Replacement)

April 14, 2024

For drivers, S stands for safety. And there are three other words that start with S that are all equally important: starting, stopping and steering. For your vehicle to be at its safest, all three functions must be in top shape. Steering is one of those things we take for granted. After all, y... More

Free Money (Almost) (Fuel Saving Tips)

April 7, 2024

You spend a lot of money on a vehicle, probably the most money you'll spend on anything except a house. But the spending doesn't stop after you've bought it. It goes into things like insurance, repairs and fuel. One good piece of news is that you can cut down the amount you spend on fuel if yo... More